With tilt swivel, with Molex adapter system. 3A charger. 12/24 Volt.
An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior!
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).
12/24 Volt. The product is E-approved. 2A charger. Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a ProClip Mounting Platform.
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
Width: 82 mm
Height: 106 mm
Depth: 68 mm
Volume: 591 cm³
Weight: 237 g
|Pedestal hoek ° t.b.v. houder||No|
|Toestel houder dikte||No|
|Toestel houder breedte||No|
|Toestel houder op- en/of afsluitbaar||No|
|Veiligheid (productinfo)||Brodit houder|
|Product geschikt voor info||Brodit houder|
- Honeywell EDA51