Brodit houder Zebra ET50/55 8.3"- extra sterk

article number
510880
Not in stock
€134.95
-
+
Details
This holder is the perfect choice when you want to have your device firmly in place within easy reach. Custom fit for bare devices (NOT for use with expansion module/handstrap/rugged frame). Attach the holder to any flat surface or a Pedestal Mount in a truck, distribution vehicle, warehouse etc. You have full access to the camera and all buttons and outlets when the device is in the holder.
 
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 15° and swivels 360°. Mounting plate 42x50 mm with predrilled AMPS-holes. Made in Sweden. Made of high grade ABS and Acetal plastic. Color: Black. Devices should not be installed onto a vehicle's dashboard if blocking the view or key controls. An installation of a device in a vehicle is always done on the customer's own responsibility.

Dimensions: 243 x 168 x 54 mm (W x H x D mm)
Weight: 353 g
More Information
More Information
Accessory brand Brodit
Barcode 7320285108806
Recommended retail price incl. VAT 134.95
Device holder type Tablet Navigation holder
Connection Passive
Professional holder extra strong version
Device holder features Device specific
Color Black
Device holder lockable? no
Productinfo Brodit houder
Product installation Mount the holder on a ProClip in your vehicle. A detailed installation manual is included in the product packaging
Product suitable for Brodit houder
Reviews
Write Your Own Review
You're reviewing:Brodit houder Zebra ET50/55 8.3"- extra sterk
Compatibility
Related products
Instruction
Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forward so it snaps into place in the holder.
 
3. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
 
4. The holder is in place. 

Scroll to top