Brodit fixed installation holder Intermec CN50

article number
532146
Not in stock
€108.95
-
+
Details
Are you using your Intermec every day in your work? Then a Brodit active holder will make your days much easier! By keeping the device in an active holder, you will always have it within easy sight and reach while driving between jobs. Not only that; this active holder supplies a fully charged
battery at all times, as well as USB on-the-go! This means that the Intermec can be run as both host and client (depending on the equipment connected to the holder).

The active holder has a unique slim design with the charging box integrated in the holder, so the cigarette lighter cable has no hefty charging box on the cable. The holder is made of black ABS plastic which is cold and heat resistant so you can use it in any environment. It is safe to use because of the short circuit protection and its high efficiency which reduces the heat produced in the unit.

Attach the holder to a ProClip Mounting Platform in order to get a firm installation in any car or truck. The holder can be used with the following cables:
Item no 945021 Micro USB - RS-232 (driver required).
Item no 945020 Micro USB - USB-A female.
More Information
More Information
Accessory brand Brodit
Barcode 7320285321465
Recommended retail price incl. VAT 108.95
Device holder type PDA holder
Connection Fixed installation
Device holder features Device specific
Color Black
Voltage 12/24V geschikt
Device holder lockable? no
Productinfo Brodit houder
Product installation Mount the holder on a ProClip in your vehicle. A detailed installation manual is included in the product packaging
Product suitable for Brodit houder
Reviews
Write Your Own Review
You're reviewing:Brodit fixed installation holder Intermec CN50
Compatibility
Instruction
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: Route the cable from the holder into the vehicle dashboard and route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis.
2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
1. Connect a micro-USB cable to the holder. Secure the cable by pulling a cable tie through the loop in the lower part of the holder.
2. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
3. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate.
4. The holder is in place.
Specifications:
Input voltage 8-30 Volt
Output voltage 4.6 Volt
Charge current 2A
Efficiency 86%
Built-in 2,5A non replaceable fuse
EC approved

Scroll to top