• Largest stock!
  • More than 15 years of experience!
  • Authorized Brodit dealer!
  • Professional advise!
  • +31 35-6780806
Language
PDAplus English PDAplus English
Toggle Nav Toggle Nav
Search

Menu

Toggle Nav
Close
Brodit holder fixed install. CAT S31
Brodit holder fixed install. CAT S31
Brodit holder fixed install. CAT S31
Brodit holder fixed install. CAT S31
Brodit holder fixed install. CAT S31
Brodit holder fixed install. CAT S31

Brodit holder fixed install. CAT S31

article number
713129
Not in stock
Be the first to review this product
€101.95
-
+
Add to order list Add to Compare
Details
Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. For fixed installation. The holder is to be connected inside the dashboard, providing an elegant installation without any cables hanging over the interior. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the phone in place in the holder so it connects to the charging, and to take it out of the holder when leaving the vehicle.
 
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Connect the power cable with a 2A fuse. Professional installation recommended. Attach onto a Pedestal Mount or an ProClip mounting platform.
More Information
More Information
Accessory brand Brodit
Barcode 7320287131291
Recommended retail price incl. VAT 101.95
Device holder type PDA holder
Connection Fixed installation
Device holder features Device specific
Color Black
Voltage 12/24V geschikt
Device holder lockable? no
Reviews
Write Your Own Review
You're reviewing:Brodit holder fixed install. CAT S31
Compatibility
Instruction
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis.
2. Connect the Red wire to a 12 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel.
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.

Cancel Continue Shopping
Scroll to top