Brodit holder Honeywell CT50/CT60

Brodit holder Honeywell CT50/CT60

Brodit

511805

Availability: Out of stock

Brodit holder Honeywell CT50/CT60
Incl. Tax: €37.50 €30.99 Excl. Tax:
When keeping your device in a passive holder, it is always within easy reach.

A portable handsfree or a charging cable can be connected to the device when it is in the holder.

The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection.

Attach onto a ProClip Mounting Platform.


Accessoiremerk Brodit
Type Device specific
Connection Passive
Pedestal lengte No
Pedestal hoek ° t.b.v. houder No
Pedestal eigenschap No
Houder professional No
Toestel connector N/A
Toestel houder dikte No
Type No
Toestel houder breedte No
Pedestal kleur No
Toestel houder op- en/of afsluitbaar No
Productinfo Brodit houder
Veiligheid (productinfo) Brodit houder
Productinstallatie Brodit houder
Product geschikt voor info Brodit houder
  • Honeywell CT50
  • Honeywell CT60
Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
To place the device in the holder: Place the bottom part of the device into the holder. Press the top of the device forward and in the same time slide the device downward into place in the holder. To remove the device from the holder: Press the upper part of the holder forward. When the device is set free, lift it upward out of the holder.
The holder is in place.