Brodit h/l Sam.Gal.Tab Active 2 USB client data out-fixed

Brodit h/l Sam.Gal.Tab Active 2 USB client data out-fixed

Brodit

713093

Availability: Out of stock

,,,
Incl. Tax: €138.95 €114.83 Excl. Tax:
Active holder for fixed installation
Fits for devices with original skin. With tilt swivel and USB Host.

Use an active holder for your Galaxy Tab Active 2 while driving and you will always have a freshly charged battery! The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Charging via pogo plug. Professional installation recommended.

Brodit h/l Sam.Gal.Tab Active 2 USB client data out-fixed

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the unit into place in the holder, and to take it with you when leaving the car.

Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.


Width: 238 mm
Height: 158 mm
Depth: 60 mm
Volume: 2256 cm³
Weight: 365 g

Accessoiremerk Brodit
Type Tablet
Connection Fixed installation
Pedestal lengte No
Pedestal hoek ° t.b.v. houder No
Pedestal eigenschap No
Houder professional No
Toestel connector N/A
Toestel houder dikte No
Type No
Toestel houder breedte No
Pedestal kleur No
Toestel houder op- en/of afsluitbaar No
Productinfo Brodit houder
Veiligheid (productinfo) Brodit houder
Productinstallatie Brodit houder
Product geschikt voor info Brodit houder
  • Samsung Galaxy Tab Active 2 (USB-C)