Brodit houder Apple iPhone 4/4S met Skins (verstelbaar)

Brodit houder Apple iPhone 4/4S met Skins (verstelbaar)



Availability: In stock

Met een passieve houder heeft u uw telefoon/PDA/tablet altijd binnen handbereik.

Omdat de houder aan de onderzijde vrij is, kan een autolader of een headset eenvoudig worden aangesloten.
Incl. Tax: €23.95 €19.79 Excl. Tax:
When keeping your device in a passive holder, it is always within easy reach.

A portable handsfree or a charging cable can be connected to the device when it is in the holder.

The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection.

Attach onto a ProClip Mounting Platform.

Tip: Install this holder with a Brodit ProClip on your dashboard Brodit ProClip.

Accessoiremerk Brodit
Type Adjustable, With case/cover
Connection Passive
Pedestal lengte No
Pedestal hoek ° t.b.v. houder No
Pedestal eigenschap No
Houder professional No
Toestel connector N/A
Toestel houder dikte No
Type No
Toestel houder breedte No
Pedestal kleur No
Toestel houder op- en/of afsluitbaar No
Productinfo Brodit houder
Veiligheid (productinfo) Brodit houder
Productinstallatie Brodit houder
Product geschikt voor info Brodit houder
  • Apple iPhone 4 (30 Pin)
  • Apple iPhone 4S (30 Pin)
Please read all of the instructions and look at the pictures before attaching the holder. 1. To adjust the holder for your device: Loosen the screws on the back side of the holder, so the sides of the holders can be adjusted. Place the device in the holder and press the sides together so the device is firmly in place. Tighten the screws on the back side of the holder.
2. To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward
4. The holder is in place.